Using Seminarraum CIP-Pool1

Overview

1(green): remotecontroll 2(yellow): powerbutton PC, 3(light rose): powerbutton screen, 4(green): HDMI-connection for own device

Content of article 

1. Using the projector
2. troubleshooting

1. Using the projector

Start of the lecture

1. Start up the stationary PC (or your own device) and log in. 
2. Point the remote control at the projector and press the power button. The light on the projector should light up red. Press the power button again, the light should now light up blue. The projector starts up, this may take some time.
3. If the source is not selected automatically, press the Source button.

After the lecture 

1. Shut down the stationary PC (or your laptop) and switch off the screen.
2. Press the power button on the remote control. A message appears on the screen asking whether the device should be switched off.
3. Press the power button again. The projector shuts down; this may take a few minutes.

3. troubleshooting

If problems occur, first try to find out where the problem lies. Go through the instructions again step by step and check that all the necessary steps have been taken. If you are using your own device, also try whether the problem occurs with the stationary PC aswell (if there are no problems, use the stationairy PC). If none of this helps, write an email to it-support[at]psychologie.uni-heidelberg.de describing the problem as thoroughly as possible. Include pictures if necessary. ⚠️A detailed description of the problem and the situation is essential so that we can solve the problem.⚠️

Note: Do you still have questions about operation? Write us an email with a request for a technical introduction. If you have any suggestions for improving this guide, please send an email to it-support[at]psychologie.uni-heidelberg.de with the subject “Suggestion Knowledgebase lecture halls”. Thank you very much!

last updated on 21.05.2025